Installation Guide

EV1 EV1
EV1 EV1
7. ADJUST DOOR THICKNESS
8. INSTALL OUTSIDE LEVER ASSEMBLY
9. INSTALL INSIDE MOUNTING PLATE AND ROSE LINER
10. INSTALL INSIDE ROSE AND LEVER
Install outside lever assembly
on the door. Make sure tail of
latch engaging with retractor
correctly as illustration left.
LOCK
BODY
ASSEMBLY
LATCH
OUTSIDE
LEVER
ASSEMBLY
a. Place mounting plate on door
face and turn up the lever slightly
and tighten screws securely.
MOUNTING SCREW
INSIDE MOUNTING PLATE
a. Press rose onto rose liner.
Be sure to fit rose in recess
of rose liner.
INSIDE ROSE LINER
INSIDE ROSE
b. Place rose liner on mounting
plate and tighten with
screw securely.
b. Use lever catch to press down
catch in the hole and push inside
lever all the way in until clicks
into catch hole.
MOUNTING SCREW
INSIDE MOUNTING PLATE
INSIDE ROSE LINER
INSIDE LEVER
INSIDE ROSE
5/16"(8mm)x2 hole
2-5/8"(66mm)
Std latch, drill 25.4mm
(1") Drive in latch, drill
24.5mm (31/32") hole
at center of door edge
2"
1-3/4"
51 45
1-3/8"
1-9/16"
35
40
TEMPLATE
2-15/32"(62.7mm)
FOLD HERE
ON DOOR EDGE
2-3/8" (60mm) BACKSET
2-3/4" (70mm) BACKSET
5/32"(4mm)
MARK CENTER OF
2-1/8"(54mm)
HOLE ON DOOR FACE
6. INSTALL REMOVABLE THRU-BOLT (SCREW POST)
OUTSIDE MOUNTING
PLATE
SCREW POST
OUTSIDE ROSE
a
b
c
a. Disassemble outside mounting plate from
outside rose plate.
b. Make clearance between outside mounting
plate and insert the removable thru-bolt
(screw post) into the cavities of outside
mounting plate.
c. Continuing the follow up instructions.
CATCH TOOL
OUTSIDE
MOUNTING PLATE
CATCH TOOL LOCATION
a. Remove outside mounting plate toward
cylindrical case.
b. Put the catch tool into the allocated position
of outside mounting plate as the illustrating
bellow.
c. Rotate outside mounting plate to required
door thickness by using a catch tool.
2"
1-3/4"
1-9/16"
1-3/8"
Align arrow mark to
be positioned in latch.
Align arrow mark to
be positioned in latch.