Operation Manual

10
GB
Setting General Data
9 Using the +/- key, set the YEAR.
If the settings for the 24-hour clock and date are not (correctly) set, the recorded training
information will not show the (correct) time.
You should now either continue or stop setting general data.
1 If you would like to continue with the printer set-up, press the MODE key.
PRT will start flash in the centre of the display.
> Continue with the Printer Set-up.
2 If you would like to stop with the 24-hour clock and date settings, press STORE (white key)
and the entered data will be saved. If you do not wish to save the data, press CANCEL (orange key).
Printer Set-up (fig.12.3)
If you have a (DOS compatible) printer with a parallel port, you can also print out the
recorded training data in Grand Excel’s memory.
PRT will start to flash in the centre of the display.
1 You can enter the following models using the +/- key: NO (no printer setting), HP DJ
(Hewlett Packard Desk Jet), HP LJ (Hewlett Packard Laser Jet), EP 24 (Epson 24-matrix printer).
You should now either continue or stop setting general data.
1 If you would like to continue switching the data logger on or off, press the MODE key.
LOG will start to flash in the centre of the display.
> Continue Switching the Data Logger On or Off and Deleting the Logger’s Memory.
2 If you would like to stop with the printer set-up, press STORE (white key) and the entered
data will be saved. If you do not wish to save the data, press CANCEL (orange key).
Switching the Data logger On or Off and Deleting the logger’s
memory (fig.12.4)
LOG will start to flash in the centre of the display.
1 Using the +/- key, you can set the data logger as follows:
LOG OFF switched off
LOG ON 5 data will be saved every five seconds
LOG ON 10 data will be saved every ten seconds
2 To delete the data logger’s memory completely, select LOG DEL ALL with the +/- key and
then press DELETE (orange key). By pressing CANCEL (orange key), you can still stop the
delete procedure. By pressing ENTER (white key), you can confirm the delete procedure.
The data logger will switch off automatically.
You should now either continue or stop setting general data.
1 If you would like to continue activating pulse rate registration, press the MODE key.
The PULSE RATE will start to flash at the right, along with ON or OFF.
> Continue with Activating Pulse Rate Registration.
2 If you would like to stop setting general data, press STORE (white key) and the entered data
will be saved. If you do not wish to save the data, press CANCEL (orange key).