Operation Manual

24
GB
Training with Grand Excel
25
Manual Setting of Slope Resistance or Watts in P0
During cycling or at rest, you can set the slope resistance (SLOPE) or power (WATT) manually.
1 Press the SET key.
SLOPE will start to flash at the bottom left.
2 Using the +/- key, set the value of SLOPE between -4 and +9 in increments of 1.
3 To save the slope value settings, press ENTER (white key) and the SET key to go to the WATT
settings.
The word WATT will start to flash at the upper left.
4 Using the +/- key, set the value of WATT between 0 and 990 in increments of 10.
5 Press the white ENTER key to save the WATT settings and then press SET to return to slope
resistance (SLOPE).
Watt (W) = Power (P) x Speed (S) As your cycling speed increases, the mag unit (P) will
require less resistance to reach the power (W) setting. Conversely, cycling slowly (with equal
setting of WATT), the mag unit will offer more resistance. If you start cycling from a stationary
position, theoretically the brake will provide infinite resistance in order to attain the WATT
setting. That is not feasible, either for the brake or the cyclist.
The WATT setting can therefore be attained within a limited range of speed. The word WATT
will then continually flash on the display. When the WATT can no longer be attained, both
WATT and FALSE will start to flash (fig.25).
SPD
PRESENT
KM
ROUTE
FALSE
STOP
TRAINING
ROUTE
CAD
WAT T
SPD
PRESENT
KM
TOTAL TRIP
STOP
TRAINING
ROUTE SLOPE
CAD
WAT T
SPD
PRESENT
KM
ROUTE
STOP
TRAINING
ROUTE SLOPE
CAD
WAT T
26
27
TOTAL TRIP
PRESENT