Operation Manual

36
GB
Error Messages
8 ERROR MESSAGES
Potential problem
1 The CycleForce frame is not
level
2 The frame has not been
assembled properly
3 The bike does not fit
properly in the frame
4 The frame is not fully
extended
1 The tyre pressure is too low
2 The roller does not press
properly against the tyre
1 A profile tyre was installed
2 There is a pebble (ticking) in
the tyre
1 The ambient temperature is
too low or too high.
2 The display does not have a
good angle of view.
3 The computer is not properly
connected to the mag unit.
4 Perspiration may have dama-
ged the computer print plate.
5 The print plate of the mag
unit is burned out.
1 It is not known whether that
part should light up.
2 The display was damaged due
to the computer having been
dropped.
Solution1
1 Place the trainer on a level floor
2 Check whether all bolts and nuts are
properly tightened
3 Check whether the Tacx Quick-release
skewer has been mounted
4 Unfold frame completely
1 Check tyre pressure, minimal
6 atmosphere
2 Turn role so that it presses solidly
against the tyre
1 Mount tyre with totally or partially
smooth tyre profile
2 Check tyre for damage
1 Use Excel at ambient temperatures
between 5°C and 35°C (40°F and
95°F).
2 Adjust the display so that you can look
directly at it.
3 Check the cable and the plug contacts
in the computer and the mag unit.
They could be dirty, oxidised or bent.
4 The print plate should be replaced.
5 The print plate should be replaced.
1 Check whether all segments work
immediately after being turned on
(fig.11).
2 The display should be replaced.
Failure
1 The arrangement of
the Basic when the
bike wobbles
2 Rubber from the
bike tyre sticks to
the roller
3 The bike makes a
lot of noise
4 Display is difficult
to read or illegible
5 Part of the display
is not functioning
Trainer
Grand Excel Computer and mag unit