Operation Manual

Assembling Grand Excel

1 ASSEMBLING GRAND EXCEL

The Grand Excel ergotrainer consists of the collapsible CycleForce frame on which you mount

your bike and the Grand Excel computer. The CycleForce is suitable for racing and hybrid bikes

and mountain bikes with a wheel diameter of 610 - 720 mm.

Assembling the Trainer

The following steps show how to assemble and adjust the trainer.

1 Press nut A into cap B and slide the cap into the frame tube (fig.1).

2 Assemble base C to the frame using bolt D. Tighten bolt D but make sure

the base is still adjustable.

3 Unfold the trainer and place it on a level surface. By fully squeezing grip E,

the trainer can be folded out or collapsed (fig.1).

4 Turn base C to the correct position (fig.2). Tighten bolt D firmly and attach

anti-slip rubber F (fig.3).

5 Assemble 2 rubber rings G and part K to handle H (fig.4). Than assemble the complete handle

to the frame, shove unit I into part K of the handle and turn bolt J until the mag unit is firmly

tightened but it should still be able to move (fig.3).

6 Replace the quick-release skewer on the rear wheel with the skewer supplied by Tacx. This

assures ideal clamp fitting and stability. Place the bike in the trainer and adjust the wing bolt L

of the trainer, so that the speed tension clamp M will close without forcing. Forcing could cause

damage!

7 Fix wing bolt L by tightening wing nut N.