Operation Manual

Assembling Grand Excel

Connecting the Grand Excel Computer

After placing the bike in the trainer, you can connect the computer as follows:

1 Assemble the computer using the two rubber clamps P on the handlebars (fig.9).

2 Connect the computer to the unit with the cable Q. Make sure that the cable is out of the way

so you won’t touch it with your shoes or pedals while cycling.

3 Place the small magnet in front of the cadence R on the inside of the left crankshaft (fig.10).

4 Assemble the magnetic sensor in front of the cadence measure S on the bottom of the left-hand

rear chain-stay. Make sure the sensor is level with the magnet, with a distance of approximately

3 mm between the magnet and the sensor. Insert the sensor’s cable in the unit. Make sure here

that the cable runs freely from the sensor and does not touch the wheel.

5 Place the plug in the power point. Check reception of the cadence metre by pedalling backwards.

The word CAD will appear on the display. The Grand Excel is now ready for use.

Perspiration and humidity could damage the printer plate in the computer. Do not use the Grand

Excel in humid spaces and if necessary dry the display after use. This will prevent unnecessary

damage. Incorrect use and/or improper maintenance will invalidate the warranty.