Datasheet

ManualsBrandsTadiran Batteries ManualsBatteries and ChargersPrimary Battery, 3.6V, Lithium

Rev. D, April 05.

Page 1 of 6

THE INFORMATION PROVIDED HERE IS NECESSARILY OF A GENERAL NATURE. SINCE SPECIFIC PERFORMANCE DEPENDS ON ACTUAL OPERATING AND STORAGE CONDITIONS,

OUR ENGINEERS WILL PROVIDE PARTICULAR APPLICATION INSTRUCTIONS UPON REQUEST. DATA SUBJECT TO REVISION WITHOUT NOTICE. ANY REPRESENTATION IN THIS

BROCHURE CONCERNING PERFORMANCE ARE FOR INFORMATION PURPOSES ONLY AND NOT WARRANTIES, EITHER EXPRESSED OR IMPLIED, OF FUTURE PERFORMANCE.

TADIRAN’S STANDARD LIMITED WARRANTY, STATED IN ITS SALES CONTRACT OR ORDER CONFIRMATION FORM IS THE ONLY WARRANTY OFFERED BY TADIRAN.

Tadiran HLC (Hybrid Layer Capacitor)

Model HLC-1520A

1. Scope

This data sheet describes the mechanical design and performance of Tadiran HLC (Hybrid Layer

Capacitor) model HLC-1520A, optimized for extreme temperatures, used in a Pulses Plus battery.

2. Characteristics

2.1. Physical

2.1.1. Length: 19.7 ± 0.3 mm.

2.1.2. Diameter: 15.1 mm. max.

2.1.3. Weight: 7.7 ± 0.2 gr.

2.2. Electrical

2.2.1. Discharge

 Discharge capacity (at RT):

 When charged to 3.67V: 140 A*sec

 When charged to 3.90V: 210 A*sec

 Discharge end voltage: 2.5V (discharge below 2.5V at RT and

discharge below 2 V at –40

C may increase

the HLC internal impedance)

 Maximum discharge current: Continuous: 500 mA

Pulse: 2 A

2.2.2. Charge (constant current)

 Max. charge voltage: 3.95 V

 Max. charging current: 25 mA

Summary of content (6 pages)

PAGE 1
Tadiran HLC (Hybrid Layer Capacitor) Model HLC-1520A 1. Scope This data sheet describes the mechanical design and performance of Tadiran HLC (Hybrid Layer Capacitor) model HLC-1520A, optimized for extreme temperatures, used in a Pulses Plus battery. 2. Characteristics 2.1. Physical 2.1.1. Length: 19.7 ± 0.3 mm. 2.1.2. Diameter: 15.1 mm. max. 2.1.3. Weight: 7.7 ± 0.2 gr. 2.2. Electrical 2.2.1. Discharge Discharge capacity (at RT): When charged to 3.67V: 140 A*sec When charged to 3.
PAGE 2
.2.3. Shelf life (Reversible Capacity): The table below describes the shelf life at different storage temperatures to 80% of initial capacity specified at paragraph 2.2.1. Temperature 2.2.4. HLC used independently HLC in Pulses Plus battery RT 3 years 10 years 60°C 4 weeks 7 years 85°C 1 week At least 1 year Self discharge current in Pulses Plus™ battery: At RT: 1µA o At 80 C: 2.2.5.
PAGE 3
2.2.7. Performance Data: VOLTAGE V VOLTAGE vs. TIME CURVES for HLC-1520A at Li/SOCl2 potential, 200 mA. 3.8 3.6 3.4 3.2 3.0 2.8 2.6 2.4 2.2 2.0 1 10 100 1000 10000 TIME [msec.] -40°C -25°C RT 72°C VOLTAGE vs. TIME CURVES for HLC-1520A at Li/SOCl2 potential, 350 mA. 3.8 3.6 VOLTAGE V 3.4 3.2 3.0 2.8 2.6 2.4 2.2 2.0 1 10 100 1000 10000 TIME [msec.] -40°C -25°C RT 72°C Rev. D, April 05. Page 3 of 6 THE INFORMATION PROVIDED HERE IS NECESSARILY OF A GENERAL NATURE.
PAGE 4
VOLTAGE V VOLTAGE vs. TIME CURVES for HLC-1520A at Li/SO2Cl2 potential, 200 mA. 4.0 3.8 3.6 3.4 3.2 3.0 2.8 2.6 2.4 2.2 2.0 1 10 100 1000 10000 TIME [msec.] -40°C -25°C RT 72°C VOLTAGE V VOLTAGE vs. TIME CURVES for HLC-1520A at Li/SO2Cl2 potential, 350 mA. 4.0 3.8 3.6 3.4 3.2 3.0 2.8 2.6 2.4 2.2 2.0 1 10 100 1000 10000 TIME [msec.] -40°C -25°C RT 72°C Rev. D, April 05. Page 4 of 6 THE INFORMATION PROVIDED HERE IS NECESSARILY OF A GENERAL NATURE.
PAGE 5
Discharge capacity vs. OCV for HLC-1520A (at RT, 50mA discharge) 4.0 3.8 OCV V 3.5 3.3 3.0 2.8 2.5 0.1 1 10 100 1000 CAPACITY [A*sec] 2.3. Safety: 2.3.1. The HLC successfully passed the following tests: Short circuit at RT Short circuit at 55°C Compression Impact Overcharge High temperature exposure Shock and vibration Forced discharge Tadiran Batteries performed the tests according to UL 1642 specification for lithium batteries. The HLC was approved by UL under file no.
PAGE 6
2.4. Temperature range: HLC used independently HLC in Pulses Plus battery Operating temperature -30 to 60°C -40 to 85°C Storage temperature -30 to 60°C -30 to 60°C Warning: The HLC is designed for use in a Pulses Plus battery or in low charge current as specified only. The HLC may explode or violently vent if over-charged above 4.4V. Charging the HLC at above 3.95V may lead to capacity loss and / or internal impedance rise. Do not charge the HLC higher than 4.