User Manual

Textile L100 Reader User's Guide
34/48 Revision 3.5 December 2007
Figure 18: Default Read Window
7. Using a ruler, measure the distance in which the antenna is able to read a C210 smart
label. If this distance is less than 100 mm., you should verify the tuning of the antenna.
10.2 Antenna Tuning Procedure
The TR-L100 Reader antenna must be re-tuned only by an approved TAGSYS integrator or by a
TAGSYS technical consultant. Any attempt by a non-qualified third-party to re-tune the antenna will
void the product’s warranty.
For detailed tuning procedures, refer to the TAGSYS Antenna Tuning Kit User’s Guide.
10.3 Upgrading the Firmware
The TR-L100 Reader has the capability to have firmware upgrades. This feature allows you to
protect your investment by upgrading your TR-L100 Reader when an enhanced chip-decoding
algorithm or new chip drivers become available.
Upgrading the Firmware of the TR-L100 Reader is a straightforward operation.
1. Install the L200 Explorer software tool on your PC. (Compatible with Windows
®
9x, NT
®
,
2000 and XP operating systems.)
2. Connect the TR-L100 Reader to the serial port of your PC and to the power supply.
3. Run the L200 Explorer software tool.
4. In the File menu, select Upgrade Firmware.
a. In the Flasher window, click Select File.
b. Select the BIN file supplied with the firmware upgrade.
c. Click Download.
When re-tuning the antenna, make sure that the TR-L100 Reader is not connected to the PC.