T-H3 Installation Manual

35 Page
TEMPERATURE REMOTE CONTROLLER
-Included accessories-Outdoor models only

1.
Take off the Back plate from the remote controller with a flat head screwdriver. (Fig. A and B)
2.
Attach the Back plate on the wall with the two provided screws. (Fig. B)
3.
If you use another cable, crimp the Fork terminals to the wires. (Fig. C)
Installaon
Installaon Manual
Fig. B
Back plate
3-1/4 inches
Attach the screws
Cut out the partition with pliers.
(removed during later steps.)
Main body
Fig. A
Main body
Twist
Press and twist flat head
screwdriver against the cutout.
Remote controller cable
1-3/8 Inch
(35 mm)
Fig. C
1-5/8 Inch
(41 mm)
Fork
Terminals
100209924 (TM-RE42)
It is also an optional accessory as a second remote for the indoor models. Refer to pp. 9 and 10.
*The optional remote controller (sold separately) has no remote controller cable.
Verify that the items listed below are included with the remote controller.
Temperature
remote controller
Screws Fork terminals Manual
Remote controller
cable*
Qty: 1
Qty: 2
Qty: 4
Qty: 1
Qty: 1
-Installaon-
 This remote controller is NOT waterproof.
 The water heater can only have one remote controller.
 Do not install in high temperature environments, high humidity conditions outdoors, in
direct sunlight, or within the reach of children.
 Make sure the remote controller does not come into contact with water or oil.
 Failure to observe these warnings could result in personal injury or electrical shock.
WARNING
 Do not place the remote controller cable close to other wires from other products.
 Cables used for the remote controller connection must be:
 Minimum 20 gauge wire (No polarity)
 Maximum 400 ft (122 m) long
NOTICE
• The remote control is an optional accessory that can be installed in a hall, closet, etc., to allow for
temperature adjustment without having to go to the heater.
• When installed, the remote will take priority over the built-in controller of indoor models.