Network Router User's Manual

TANDBERG GW Data port Command Interface User Guide
6
3. Connecting to the Data port Command Interface using Telnet
The TANDBERG 3GW has one LAN port.
The GW’s Telnet server provides access to the Data port Command Interface through a
10/100 base T network interface supporting the TCP/IP protocol.
When connected to the 3G Gateway, type tsh to start a t-shell from the command line. The
Telnet client will receive a welcome message similar to the following:
Welcome to TANDBERG
TANDBERG 3G Gateway Release R2.0 customer
SW Release Date: 2006-03-28
NOTE! If the TANDBERG 3GW is protected by an IP password you will be prompted to enter
this password before you can access the Data port Command Interface via Telnet.