Instructions

----- 4 -----
5. Configuration
The device can be configured via DIP switches and jumpers manually or with the
corresponding software “Digalox Manager” via USB interface. When configuring via
DIP switches and jumpers the basic settings can be made computer-independent. The
configuration with the software “Digalox Manager” allows full functionality.
Setting scale via DIP switch
When setting the scaling via DIP switch to represent the correct measurement value
(e.g. 60mV DC for shunt) the upper scale caption corresponds to the primary value of
the shunt. Example:
upper scale caption = 250 = primary value shunt
Configuration via USB interface with software “Digalox Manager”
Visit www.digalox.com to download software “Digalox Manager”. For use with software
set DIP switch 10 to OFF position.
Please note that the measuring mode selected in "Digalox Manager" is displayed only
until the power supply of the DPM72 is interrupted.
Configuration via DIP switches and jumpers if only one measurement mode is
required (Manual mode)
1. Set DIP switch 10 to ON position.
2. Set measurement mode with jumpers at J4-J6 according to table "Measurement
mode”, column “Manual mode".
3. Set upper scale caption for the first measurement mode with DIP switches 1-9
(see “Configuration of the upper scale caption”).
4. Connect supply voltage.
In further operation, the device always shows the measurement mode,
which is set by the jumpers J4-J6 or the DIP switches 11-12 respectively!
(see table "Measuring mode").