User manual

63
8.3ISOLATED PROGRAMMING&MONITORING CONNECTOR
Refer to Table8-1 for detailed descriptionofthe rear panel IsolatedProgramming&Monitoring
connector. To providethe lowest noise performance, it is recommended to useshielded-twisted
pair wiring.
Refer to Fig.8-1for descriptionofthe connector.
1
2
3
4
5
6
7
8
Shield
+VPROG_ISO
+IPROG_ISO
GND
Shield
+IMON_ISO
+VMON_ISO
GND
+VPROG_ISO
Terminal
Signal name
Function
Shield, connected internally to
chassisofthe supply.
0-5/0-10V
0-5/0-10V
0-5/0-10V
0-5/0-10V
4-20mA
4-20mA
4-20mA
4-20mA
Range 0-5/0-10V
IS510 option
Range 4-20mA
IS420 option
Chassisground
Chassisground
SHLD
1
Output voltage programming input
Output current programming input
2
+IPROG_ISO
3
Ground forprogramming
signals.
Ground forprogramming
signals.
Output voltage monitoring output
Output current monitoring output
Shield, connected internally to
chassisofthe supply.
GND
GND
+VMON_ISO
+IMON_ISO
SHLD
4
5
6
7
8
Ground
Ground
Ground
Ground
Table8-1: Detailed descriptionofIsolated programming&Monitoring connector
Fig.8-1: Isolated Programming&Monitoring connector
Isolated programming plug P/N: MC1.5/8-ST-3.81, Phoenix.
CAUTION
Parallel Operation: Optional Isolated Analog IS510 / IS420 must be
installed in both the Master and Slave unit.
When the Isolated Analog Optionisinstalled, do notapply any signalstothe
non-isolated VPGM and IPGM (J1-9 and J1-10) pins. All other J1 features
may be used normally. Refer to Section4.5 foradescriptionofJ1features.
63