User's Manual

Troubleshooting Specifications
Amplifier Section
Power output................................. 200 W + 200 W (8 Ω)
300 W + 300 W (4 Ω)
Frequency response ........................10 Hz - 30 KHz (-0.5 dB)
Signal noise ratio.............................. 102 dB (A-weighted)
Total harmonic distortion ............................ 0.01 % or less
Input sensitivity ..................................... 280 mV/47 KΩ
General
Power Requirements............................... AC 230 V 50 Hz
Power Consumption (nominal).............................. 570 W
Dimensions (W x H x D) ....................... 435 x 230 x 520 mm
Weight..................................................... 31.3 kg
Operating temperature ............................... +5˚C - +35˚C
Operating humidity.................. 5 % - 85 % (no condensation)
Storage temperature................................. –10˚C - +55˚C
Accessories
Power cord x 1
Remote control x 1
AAA battery x 2
Warranty card x 1
Owner's manual x 1
Design and specifications are subject to change without notice. o
Weight and dimensions are approximate. o
Illustrations may differ slightly from production models. o
11
ENGLISH
If you experience any problems with the unit, please take a moment
to look through this chart before asking for repairs. If you still have
a problem, contact your dealer or TEAC customer service/technical
support (stated on the back cover).
No power
e Check the connection to the AC outlet. Check and make sure
the AC source is not a switched outlet and that, if it is, the switch
is turned on. Make sure there is power to the AC outlet by
plugging another item such as a lamp or fan into the outlet.
Remote control doesn't work.
e Press the POWER switch of the main unit to turn it on.
e If the batteries are dead, change the batteries.
e Within the specified range of 10m, point the remote control
directly at the unit's front panel.
e Clear any obstacle between the remote control unit and the
main unit.
No sound
e Check the connection to the amplifier.
e Check the operation of the amplifier.
e Muting is activated. Press the MUTE button. Select the correct
source.
e Output protection has been activated. Turn off the unit,
check for possible causes (e.g. short-circuited speaker cables,
connected speakers with wrong impedance) and solve the
problem. Wait 5 minutes before turning on the power again.