User Manual

ManualsBrandsTeac ManualsComputer Accessories & Peripherals1.44 MB, 3.5-Inch PS2 Floppy Drive

TEAC FD-235 Series

3 1/2" 1.44 MB Floppy Disk Drive

Installation Guide

3 1/2'' diskette

insertion window

Activity indicator

Eject Button

Your FD-235 package includes:

* FD-235 3 1/2" floppy disk drive

* Installation Guide

Introduction

Thank you for purchasing the TEAC FD-235 Series 1.44 MB floppy disk

drive. This product is intended for use in IBM PC/AT compatible computers.

This quality drive will provide trouble-free operation for your computer

system if properly installed. PLEASE READ THE ENTIRE INSTALLATION

GUIDE THOROUGHLY BEFORE YOU BEGIN THE INSTALLATION.

Use a standard floppy controller card or the floppy connector (34 Pin) on

the motherboard.

Summary of content (4 pages)

PAGE 1
TEAC FD-235 Series 3 1/2" 1.44 MB Floppy Disk Drive Installation Guide 3 1/2'' diskette insertion window Activity indicator Eject Button Your FD-235 package includes: * FD-235 3 1/2" floppy disk drive * Installation Guide Introduction Thank you for purchasing the TEAC FD-235 Series 1.44 MB floppy disk drive. This product is intended for use in IBM PC/AT compatible computers. This quality drive will provide trouble-free operation for your computer system if properly installed.
PAGE 2
Preparing your Personal computer for FD-235 Floppy Drive Installation CAUTION: TURN OFF YOUR COMPUTER AND UNPLUG IT FROM THE AC POWER SOURCE BEFORE INSTALLING THE FD-235. FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK. 1. Unplug your computer from the power source. 2. Remove cover from your computer. Refer to your computer system manual for this procedure. 3.
PAGE 3
Configuring for A: or B: drive Use a standard IBM PC compatible cable with a twist at the end connector (Figure B) to complete installation. Cable’s colored-line denotes Line 1 to match to Pin 1 on drive and motherboard’s connectors. a. To configure as your A: drive, connect the FD-235 Series floppy drive to Connector A: on the flat “ribbon” cable. Connector A: is the end connector of the cable as shown in Figure B. b.
PAGE 4
Trouble Shooting Symptom Solution Indicator light never turns on when executing READ or WRITE Ensure proper interface cable and power cable connection and CMOS setup configuration. Indicator light comes on as soon as power is applied and stays on. The ribbon cable may be reversed. Check Pin #1 orientation. Possible bad cable. Drive type mismatch during boot Check CMOS setup for correct drive type: 3.5" 1.44 MB. Invalid media or Track 00 bad when formatting.