User Manual

3
Configuring for A: or B: drive
Use a standard IBM PC compatible cable with a twist at the end connector
(Figure B) to complete installation. Cable’s colored-line denotes Line 1 to
match to Pin 1 on drive and motherboard’s connectors.
a. To configure as your A: drive, connect the FD-235 Series floppy drive to
Connector A: on the flat “ribbon” cable. Connector A: is the end
connector of the cable as shown in Figure B.
b. To configure as your B: drive, connect the FD-235 Series floppy drive to
Connector B: on the flat “ribbon” cable. Connector B: is the middle
connector of the cable as shown in Figure B.
c. Make the correct changes to the CMOS BIOS setup after you install
your FD-235. Configure Floppy A: to 3.5" 1.44 MB.
d. Upon rebooting, the Operating System (DOS, Windows) will recognize
the floppy disk drive. There are no drivers required.
FIGURE B
Pin #1
I/F Cable
Twist
Connector B:
Connector A: