DISC LABEL PRINTER INSTRUCTION MANUAL P-55

SECTION 5 : Installing/Removing Shipping Protection Materials

To prevent the product from being damaged in shipment, cushioning materials and fixing metal are

used to secure the internal parts to the unit. Make sure all those protection materials are removed

before use. For the future shipment, keep the fixing metal and packing (3 types) in the packaging

box along with packing materials.

To prevent the product from being damaged in shipment, install the shipping protection materials in

reverse order to the removal procedure.

The P-55 is a precision machine. Be careful not to drop or subject the unit to severe impact (it

weighs more than 22 kg).

This product internally reaches a high temperature when in use. Before installing the shipping

materials in the unit, leave it turned off for a while (1 hour) to cool it off completely.

Make sure the ink ribbon and transfer ribbon are removed when the shipping protection materials

are installed in the unit.

1. Peel off adhesive tape A from the top left of the unit and press unlock button B to open side door

2. Loosen the screw

D and pull out the metallic bar E. Insert the removed metallic bar into position

marked

F to keep it for future use.

3. Peel off adhesive tape

G, flip up lock lever H to unlock the ribbon cartridge and remove two

cushions

I by pulling them toward you.

4. Pull out ribbon cartridge

J, remove cushion K and then put back the ribbon cartridge to its place

for the moment. (You may want to keep the cartridge removed to load ribbons as discussed later,

in SECTION 12 : Loading Ribbons.)

5. Flip down lock lever

H to lock the ribbon cartridge in place and lift up the side door until it locks.

Do not t

ry to forcibly close the side door without flipping down the lock lever, or the side door may

be da

maged.

NOTE