Operation Manual

BRC stand usage and battery charge

The BRC (optional accessory) contains a powerful rechargable Lithium Ion battery,

which allows many hours of wireless operation for the WAP system, due to high

battery capacity and the integrated power saving management of the BRC.

Before first wireless BRC usage, the battery requires recharging.

Connect the BRC power supply to the backside connector of the stand.

The BRC can be operated while placed in the stand.

Note: Charging control even works when the BRC is switched to Standby!

The charging progress you can control by the flashing battery symbol in the display

headline: Red = battery low, Yellow = medium charge, Green = fully charged. When

the battery is fully charged, flashing of the battery symbol stops. In case of green

and not flashing battery symbol, charging procedure is switched off. If you keep the

BRC on the stand with power supply connected, even uninterrupted display and

SMR connection will not discharge the battery.

Note: If you aim for not using your WAP for longer time, disconnect the BRC from

charger and disconnect it from mains, to avoid unexpected discharge of the battery.

Also disconnect the power supply of the SMR.

Under normal usage conditions after full charge, the BRC might be operated for

several days before recharging will be required. In case of extensive usage (display

all time active) the BRC can be operated apprx. 8 hours. But uninterrupted usage is

not usual without power supply. If you aim for continous display and instand access

all time, you can connect the BRC to power supply (operate the BRC on the stand).

Li-Ion battery replacement:

● The Battery compartment is placed at the back of the BRC cabinet.

● The battery cover slider can be unlocked by slight pushing the cover at the

dotted area and shifting down for apprx. 5mm. After unlocking, the cover

can easily be removed.

● Please pull out the small battery connector carefully, replace the battery and

plug-in the small battery plug again.

● Then lay the battery cover back on the opening and let it slide-in until you

recognize it was locked again.

● The BRC now is ready to use.