Instruction manual

Start-Up

Follow these steps to start-up your WAP-V6000

Turn on the TV Screen. Set the video sources selector on your TV to match the

connection from your WAP-V6000. For example, if you used HDMI, set the TV to

use “HDMI” Input.

1. Turn on WAP-V6000. The LED on the front panel of the WAP-V6000 lights

up to show that it is powered on.

2. Check the TV display. The default display of WAP-V6000 is

Composite(CVBS). If you use HDMI, take the remote control and push

OUTPUT Key. You can cycle through the TV modes to get the appropriate

display output.

3. Wait a few seconds for the start up page to show up, and it will turn into the

Main Menu.

The start up page will last for only few seconds, and then go to the Main Menu. If

there is still no video output after the start up page appears, please make sure the

WAP-V6000 and the TV are in the same mode. If not, please cycle through the

OUTPUT key on the remote control, wait few seconds during each cycle to establish

the next mode.