Instruction manual

Firmware Upgrade and Reset to Default

Upgrade by Using USB Flash Disk

WAP-V6000 supports using USB storage for updates. Follow the steps below to

check for product updates:

1. Have your USB storage ready, download by computer the latest firmware

from www.teac.de to USB storage.

2. Insert the USB flash to the USB port of WAP-V6000.

3. Go to “Set Up Main Menu” “Version” and choose ‘Firmware upgrade” 

4. Choose “USB Upgrade”, the system will automatically search available

firmware code on your attached USB storage.

5. Follow the onscreen instructions to complete the upgrade.

6. When the upgrade is successfully finished, WAP-V6000 will reboot

automatically.

ATTENTION: Do not power off the system or remove the USB storage while the

upgrade process is running.

Reset to Default

You can restore all configurations to factory default settings by following below

steps:

1. Go to “Set Up Main Menu” “Version”, and choose “Reset to Default” 

2. Make sure you want to do so, then press “OK” button to restore system to

default settings.

ATTENTION: Restoring WAP-V6000 to its default settings will erase the network

set up and media sever configuration. You will need to set up WAP-V6000 again to

run on your network and to access media files.