Installation Sheet

1.0
Installation Instructions for
Kamden 4 Light Bath
700BCKMD4
1
920BCKAMD4
2
1
With the provided Allen wrench, remove the Allen screws on both sides of the fixture base.
Remove the mounting plate from the back of the fixture.
Attach the mounting plate to the electrical box using the two provided #8-32 screws.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line.
Connect the black driver wire to the hot power line.
Properly place the all wires and wire nut connections into the electrical box, then mount the fixture back onto the mounting plate and
reinstall Allen screws (reversal of step 1A).
If necessary, install the diffusers into the diffuser bases which are secured together by magnets.
Optional: This fixture features a slotted mounting plate allowing the fixture to be slid left or right for easier positioning. To achieve this,
loosen the Allen screws with the provided Allen wrench, slide the fixture base left or right until the desired position is reached, and re-
tighten the Allen screws to secure in place.
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1A
Install the Fixture
4
3
6
5
7
GENERAL PRODUCT INFORMATION:
These fixtures are intended to be installed
utilizing NEC compliant junction boxes.
This product is suitable for damp locations.
This product may be dimmed with a low-voltage electronic
dimmer.
This instruction shows a typical installation.
BCATH OLLECTION
5
8
DIFFUSER
DIFFUSER
BASE
4
6
8
ALLEN WRENCH
ALLEN SCREW
#8-32
SCREW
MOUNTING PLATE
SLOT
9