Installation Sheet

2
2B
3
4
Bring the power wires to the fixture location in
accordance with local electrical codes.
Line-voltage only: connect the fixture to a suitable
ground in accordance with local electrical codes.
Line-voltage: Connect the white fixture wire to the
neutral power line wire with the provided outdoor
waterproof wire nut.
Low-voltage: Connect the white fixture wire to one of
the low-voltage power line wire with the provided
outdoor waterproof wire nut.
Line-voltage: Connect the black fixture wire to the hot
power line wire with the provided outdoor waterproof
wire nut.
Low voltage: Connect the black fixture wire to the
remaining low-voltage power line wire with the
provided outdoor waterproof wire nut.
5A
6A
3
4
5
6
2C
7
Stake the fixture to the desired location and properly
bury the wire and wire nut connections.
Note for In-Line Fuse equipped fixtures: in the
case that the fixture is not operating correctly,
make sure to check the fuse.
Note for Photocell equipped fixtures: at initial
power up, the photocell must calibrate which will
cause the fixture to cycle on/off for a moment.
5B
6B