Installation Sheet

Installation Instructions for

Stratos 24 and 30 Chandelier

Prepare the Canopy

Remove the crossbar from the canopy by completely

unscrewing the decorative bolt.

920STRATCH

DECORATIVE

BOLT

CROSSBAR

CANOPY

1.1

700STR_

CHANDELIER

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

This fixture is intended to be installed utilizing NEC

compliant junction boxes.

This product is suitable for damp locations.

This product may be dimmed with a TRIAC, low-voltage

electronic or 0-10V dimmer.

Mount the crossbar assembly to the electrical box with

the two provided #8-32 screws.

#8-32

SCREW

CROSSBAR

PAGE 1
920STRATCH Installation Instructions for Stratos 24 and 30 Chandelier 700STR_ 1.1 CHANDELIER GENERAL PRODUCT INFORMATION: This fixture is intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product may be dimmed with a TRIAC, low-voltage electronic or 0-10V dimmer.
PAGE 2
Shorten the Cords (Optional) 1C 2A DUMMY COAXIAL CORD - 5 3 COAXIAL CORD Line an anchor tip with the center of an anchor holes, and push the anchors into the wall up to the threads. 4 Screw the anchors in the rest of the way with a Phillipshead screwdriver.
PAGE 3
Wire the Fixture Complete Installation 3A 4A CANOPY 1 3 4 - 5 - 6 2 + + 1 2 DRIVER Connect the fixture ground wire to a suitable ground in accordance with local electrical codes.
PAGE 4
Install Glass Panels 6C 6A 6 Take a large panel and slide it under the small panel installed in the last step, align the mounting holes and secure in place with a provided thumb screw. 7 Continue this process until you have install all glass panels. NOTE: It is recommended that two people complete the following steps to ensure the glass is installed safely. 1 2 Start with one of the large glass panels and secure one side of it by using a provided thumb screw. (Do Not Over-Tighten Thumb Screws.