Installation & Assembly

ManualsBrandsTech Lighting ManualsChandeliersMara 25-Light LED Sputnik Modern Linear Chandelier

1.1

Installation Instructions for

700 _TDMRA

920MARA

CHANDELIER

Mara Chandelier

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

This instruction shows a typical installation.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Mounting Plate

Secure the mounting plate to the electrical box with the

two washers and #8-32 screws provided.

Remove all the canopy screws using the provided Allen

Wrench.

Remove the mounting plate and driver from the canopy.

#8-32 SCREW

AND WASHER

MOUNTING PLATE

MOUNTING

PLATE

CANOPY

SCREW

1 1

CANOPY

DRIVER

3 3

Two Person Installation Recommended

ALLEN WRENCH

Summary of content (4 pages)

PAGE 1
920MARA Installation Instructions for Mara Chandelier 700TDMRA_ 1.1 CHANDELIER GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This instruction shows a typical installation. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
Assemble the Fixture Install the Fixture 2A 3A FIXTURE WIRES 1 HALF BALL/ UPPER STEM ASSEMBLY DRIVER CANOPY 2 1 CANOPY 2 1 Connect the black driver wire to the black fixture wire with a wire nut. 2 Connect the red driver wire to the red fixture wire with a wire nut. 3 Neatly place the driver and wires inside the canopy. 3B 2 4 5 STEM 6 FIXTURE 3 1 Feed the half ball/upper stem assembly through the top of the canopy.
PAGE 3
Install the Glass 3C 4A ELECTRICAL BOX 8 8 CANOPY SCREW 8 ALLEN WRENCH CANOPY BASE GLASS 7 Neatly place all wires and wire nut connections inside the canopy. 8 Align the canopy holes with the mounting plate holes. Secure the canopy in place by tightening the canopy screws using the provided Allen Wrench. 1 3 Install the glass by screwing it into the base. Do not over-tighten.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.