Instructions / Assembly

BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND
WARNINGS.
❶ Do a quick inventory to
make sure the package
contains all the parts and
hardware listed in the
assembly instructions.
❷ Missing, damaged
and defective parts can
be replaced at no cost to
you. Please refer to the
last page in this manual.
❸ The replacement parts
service is limited to the
continental United States. If
you reside in Hawaii, Puerto
Rico, U.S. Dependencies or
other countries, please
contact the supplier from
where the unit was
purchased.
❹ If during assembly
you find an issue or
need clarification, please
contact our Customer
Service for assistance.
Please refer to the last
page in this manual.
❺ On each step read
the instructions and
analyze the illustrations
thoroughly before
proceeding to do the
assembly.
❽ Do not overtighten
or force the screws as
they might break, strip,
damage the threads of
the holes or get stuck
inside the part.
❻ Make sure you
understand which hardware
will be used on each step.
Using the wrong size of
screw, bolt or pin might strip
the threads or cause
damage to the part in which
it is being used.
❼ To avoid
misalignments, always
leave the screws loose
and tighten them until
all pieces are
positioned correctly.
❾ If the hole seems too big or too small for the
screw, first make sure you are using the correct
size of screw and that it’s been installed in the
correct hole. Test another of the same screw
into the same hole, as well as test the screw
onto different holes for the same part. If the hole
still appears to be too small, do not force it, it
needs replacing.
P. 3
Models: TS70, TSF71
P. 3