Instructions / Assembly
CHAIR’S FUNCTIONS
① Chairs’ height: Pull UP the lever under the seat. The chair goes down while sitting on it, or up if
you lift your body.
② Seat tilting: Pull the same lever OUT horizontally to unlock this function, and IN to lock again.
NOTE: Unlike regular office chairs, this racing/gaming chair has its base components
off-center, and the tilting won’t be much and might actually feel hard to tilt.
③ Tilt tension: Turn the mechanism’s knob in either direction to apply more or less tension. With
less tension, the tilting will feel easier. Please read the above note about the tilting.
④ Backrest reclining: pull UP the lever located on the rear right side of the seat and release it
when the desired position is reached.
WARNING: For your safety, the seat’s tilt function ② should be in the LOCKED (IN) position
prior to use the backrest reclining function.
⑤ Armrest height: Pull UP the button that is under the armrest.
WARNINGS
• Do not exceed the indicated weight limit.
• Do not stand up on the chair or use it as ladder.
• Use the chair to seat only one person at a time.
• Do not use the chair if parts are damaged or if screws are loose or missing.
• Do not sit near the edge of the seat and always sit properly on the chair to avoid going
beyond your balance point and fall off the chair.
• The chair is intended for teenagers and adults. If small children are using the chair,
please keep close observation on them.
• Do not allow small children to play with the chair.
• Not paying attention to these warnings could result in severe injuries.
• To clean the chair it is recommended to use a soft cloth lightly damped in a solution of
smooth soap and water, then dry with a clean towel.
• Do not use solvents or abrasive materials to clean any part of the chair.
• Before applying a cleaning agent, test on a small hidden area of the chair, like
underneath the seat.
• Do not expose the product to direct sunlight or to extreme environmental conditions.
• Every 4 months, inspect the chair completely and make sure that all screws are
tighten.
CARE AND MAINTENANCE
P. 6
Models: TS70, TSF71
P. 6
❹
❷
❸
❺
❶
Weight
Limit:
250
Lbs