Operation Manual

Handleiding Internet van Ziggo 15
Check with your cable company to make sure you have everything you need to
begin; they’ll know if you need to install special software or re-configure your
computer to make your cable internet service work for you.
3.2.3 Contact your local cable company
You will need to contact your cable company to establish an Internet account
before you can use your gateway. You should have the following information
ready (which you will find on the sticker on the gateway):
• The serial number
• The model number
• The Cable Modem (CM) Media Access Control (MAC) address
• The Terminal Adapter (EMTA) MAC address
• Security information: Service Set Identifier (SSID), Encryption key /
passphrase (WPA2-PSK by default), channel number. Default values are
indicated underneath the modem on the sticker.
Please check the following with the cable company
• The cable service to your home supports DOCSIS/Euro-DOCSIS compliant
two-way modem access.
• Your internet account has been set up. (The Media Terminal Adapter will
provide data service if the cable account is set up but no telephony service
is available.)
• You have a cable outlet near your PC and it is ready for Cable Modem
service.
Let op!
It is important to supply power to the modem at all times. Keeping your modem
plugged in will keep it connected to the Internet. This means that it will always
be ready whenever you need.
Important Information
Your cable company should always be consulted before installing a new cable
outlet. Do not attempt any rewiring without contacting your cable company
first.
Please verify the following on the Wireless Voice
Gateway
The Power LED should be lighted when plug-in the power supply.