Operation Manual

Handleiding Internet van Ziggo 17
3.3.2 Installation procedure for connecting to the
Ethernet interface
Follow these steps for proper installation. Plug the coaxial cable to the cable
wall outlet and the other end to the modem’s cable connector.
Let op!
To ensure a fast registration of the modem, the coaxial cable must be
connected to the modem before it is powered on.
Plug the power supply into the socket of the cable modem and two-pin plug in
the AC outlet then press the Power Switch, power on the modem.
Let op!
Only use the power supply that comes with the modem. Using another power
supply can cause damage to the product, and will void the warranty.
Connect an Ethernet cable (direct connection, see below) to the Ethernet port
at the back of the computer, and the other end to the ETHERNET port on the
rear panel of the cable modem. The modem will seek the appropriate cable
signal on the cable television network and go through the initial registration
process on its own. The modem is ready for data transfer after the green LED
"ONLINE" is lit continuously.
Let op!
the button "reset" at the back of the modem is used primarily for maintenance.
figure 6: Connect to the modem