- Technisat DIGIT MF4-S Operating Manual

The test transponder you have set will now check whether a
signal can be received at this position. The system will also
check whether the position to be saved is identical to a
position available in the pre-programmed satellite position
list. (Fig. 9-14)
If this is the case, the following message will be
displayed:Orbitalposition xx found. Save satellite ?
(Fig. 9-15)
> To save the satellite position, use the arrow keys
left/right to mark the field Yes , then confirm by pressing
OK.
If on checking the test transponder does not identify a pre-
programmed satellite position, or if the signal received is too
weak, a corresponding message will be displayed. (Figs. 9-
16 and 9-17)
> To save the satellite position, use the arrow keys
left/right to mark the field Yes , and confirm by pressing
OK.
9.4 Current satellite list
The satellite positions saved are included in the satellite list.
Positions not yet saved are marked in the list with a “*”.
> To turn the dish to a position included in the satellite list, use
the arrow keys to mark the field Current satellite list.
> Confirm by pressing OK.
> Use the arrow keys up/down to select the desired
position.
> Confirm by pressing OK.
The dish will now be turned to the position selected. The
rotating procedure will be indicated by the blinking display
“turn” in the menu.
9.4.1 Addressing a satellite position
To turn the antenna to the position set in your satellite list, your
digital receiver is equipped with the function turn to sat.
> Press the yellow function key Actions to open the window
showing the available actions.
> Now use the arrow keys up/down to mark the line turn
to sat.
> Confirm by pressing OK.
> Press the green function key (turn to sat) to turn the
antenna to the satellite position selected.
61
(Fig. 9-16)
(Fig. 9-17)
(Fig. 9-14)
(Fig. 9-15)