Instruction Manual

2-8
2.6 USING OPERATOR DIRECT COMMANDS (Level 1) - continued
0 (PROG) - Menu Level Up
Pressing this key selects the next Higher Menu Level, the Menu Level is indicated in the 4 character position
th
on the lower row of the display. The Menu Level is indicated in subscript and is as follows:
Table 2.7 Keypad Menu Level
Level Display
1 direct blank
2 programming 2
3 maintenance 3
Upon pressing this key, the radio will remain in the new Command Level for 5 seconds, if there is no further
user input within this time frame then the radio will revert to the Direct Command Level. The Direct Command
Level (level 1) is the normal operating mode for the radio.
NOTE: The Operator Direct Command Level (level 1) is indicated by a blank space, this is the normal
operating mode of the radio.
‘ENTER’ – save changes to selected channel if any
If there have been changes made to the current operating channel, pressing ‘ENTER’ will allow the user to
save these changes to the channel memory.
‘ESC’ – Menu Level Down
Pressing this key selects the next Lower Menu Level, the Menu Level is indicated in the 4 character position
th
on the lower row of the display. The Menu Level is indicated in subscript and is as given in the table in ‘0’
above.