Operation Manual

ManualsBrandsTechno line ManualsAir ConditioningWS 6850

WS6850 Desktop Weather Station

Instruction Manual

Introduction

This desktop weather station comes with barometric weather prediction, clock, calendar,

indoor and outdoor temperature and humidity display. It is battery powered with AC

charger. It is recommended to use the AC charger at all times.

Fig. 1 Front view Fig. 2 Back view

1. MODE button

2. +/°C/°F button

3. -/ RCC button

4. SNOOZE/ LIGHT button

5. HISTORY button

6. CHANNEL button

7. MAX/ MIN button

8. DC line in jack

9. Battery compartment

General notes:

1. It is recommended to set up the remote temperature sensor before setting up the

weather station/ clock. See “Configuring Remote Temperature Sensor(s)”

for more information. Batteries and AC adapter should be used together.

2. Please note all other clock/ weather station settings seize to function when the

clock is in RCC synchronization mode. See “RCC Synchronization” for

additional information.

3. During initial installation, the temperature and humidity sensor may take up to an

hour or more to acclimatize to current conditions.

4. Press SNOOZE/ LIGHT (4) to change LCD screen backlight brightness from OFF,

LOW and HIGH.

Getting started:

Installing AC adapter

Summary of content (8 pages)

PAGE 1
WS6850 Desktop Weather Station Instruction Manual Introduction This desktop weather station comes with barometric weather prediction, clock, calendar, indoor and outdoor temperature and humidity display. It is battery powered with AC charger. It is recommended to use the AC charger at all times. Fig. 1 Front view 1. 2. 3. 4. 5. 6. 7. 8. 9. Fig.
PAGE 2
1. Plug in AC/DC adapter at DC input jack (8) (see fig. 2). Use only approved adapters. Batteries installation 1. Open battery compartment (9) on the back of the unit (see fig. 2). 2. Install/ replace 2 x AAA size batteries in the compartment. It is recommended that only alkaline batteries are used. 3. Replace the battery compartment (9) on the back of the unit. 4. A short beep will be heard to confirm proper installation of batteries. 5. It will take approximately 3 seconds for the screen to light up. 6.
PAGE 3
4. Press HISTORY button (5) to confirm weather pattern. Interpreting the weather forecast symbols The weather station requires at least 24 hours on acclimatizing to local weather conditions. The weather station process and analyze the weather patterns for the past 24 hours in order to determine the future weather. Until that time has elapsed, the predicted weather forecast may not accurately reflect the actual weather for your immediate area. The weather station will display the symbols (see fig.
PAGE 4
Note: It is only possible to measure the barometric pressure trend properly when the unit remains at the same altitude. When moving around at different altitudes within a short period of time, the air pressure and the barometric pressure will change. The pressure trend will only be correct and regulate the has remain at a constant altitude for 24 hours or more.
PAGE 5
RCC Zone Offset This clock is equipped with radio controlled time adjustment. The user will need to work out the time zone signal they receive at their current location and make (any) adjustment as required. This function also allows for daylight saving adjustment. Contact your local weather bureaus or authorities for more information. Press -/ RCC button (3) once for +1 time zone. Press -/ RCC button (3) once again for +2 time zone. Press -/ RCC button (3) once again for -1 time zone.
PAGE 6
time. Configuring the Thermometer This weather station is equipped to synchronize up to 3 remote temperature sensors. One remote temperature sensor is included. Additional remote temperature sensor is available for purchase separately. Please contact your local distributor for purchase. Remote temperature sensors Fig. 4 Back View RTS 1. RTS 2. RTS 3. RTS 4. RTS 5. Fig. 5 Back view - open Hang hole Battery compartment screws TX button RESET button CHANNEL 123 switch Batteries installation 1.
PAGE 7
extreme or harsh weather, including but not limited to hurricane, typhoon, and cyclones seasons. Do not place the unit in area of high winds. 3. Do not place the remote temperature sensor more than 30 meters (98 feet) from the receiving weather station. The remote temperature sensor is most effective if there are no obstruction and interference between the remote temperature sensor and the weather station.
PAGE 8
4. When is shown, the display will automatically show through all the remote sensors channel. Press CHANNEL button (6) to cancel. Celsius / Fahrenheit 1. Press +/°C/°F button (2) to toggle between displaying the temperature in Celsius and Fahrenheit. Temperature Trend 1. indicates the temperature is in a increasing trend. 2. indicates the temperature is in a no change trend. 3. indicates the temperature is in a decreasing trend.