Operation Manual
MYRUN TECHNOGYM
20
Turning on and o
Turn the unit on only after completing its assembly.
To turn the unit on, ip the main switch to position “I” (on).
After a quick system check (reset), the equipment is ready for use.
To turn the unit o, switch the main switch to position “0” (o).
Turn the unit o only at the end of the exercise, when the belt is not turning.
If the unit is not expected to be used for a long time, in addition to turning it
o with the main switch, you should also pull the plug out of the wall socket.
W
The switch is used to turn the unit on and o, but does not fully
disconnect it from mains power, even when set to the “0” (o)
position. For complete disconnection you must remove the
plug from the power supply.