Operation Manual

MYRUN TECHNOGYM
27
Routine maintenance
W
The safety of the equipment is assured only on the condition that it is carefully inspected every two weeks for any signs of damage
and/or wear.
Replace defective and worn components immediately, or alternatively remove the equipment from service.
Call the Technogym Technical Support Service for instructions on any maintenance operations not described in this manual.
The unit should always be kept clean and free of dust, in accordance with normal hygiene and sanitary practices.
To clean the control panel, proceed as follows:
- turn the unit o by moving the main switch to position “0”;
- unplug the equipment power cable from the wall socket;
- clean the control panel with a damp, but not wet, cloth.
Clean the equipment completely every week:
- when the unit is turned o, clean the external parts with a damp sponge;
- set the running surface at the maximum gradient and use a vacuum cleaner to clean the lower side of the unit close to the guard, and the oor;
- clean the running surface with a brush with nylon bristles or a clean synthetic broom, while the belt is turning with no one using it.
Do not use chemicals or solvents. Do not use abrasive products on polished parts.
Make sure you do not rub too hard on the control panel.