Operation Manual

MYRUN TECHNOGYM
A
B
C
D
28
Treadmill belt alignment
When the equipment is running the treadmill belt must be centrally aligned
in relation to the frame; if the treadmill belt tends to move either to the right
or left, or if it is not in the centre, it must be centred.
Open ap (A) with the belt stopped.
Start the belt at the speed of 3 km/h.
Turn the adjustment screw (B), located at the rear of the equipment, until
the belt is centred.
The outer edge (C) of the logo on the belt must remain within the marks (D)
on the casing.
Turning the screw clockwise moves the belt to the right; turning it anticlockwise
moves it to the left.
The belt alignment adjustment is performed slowly: turn the adjustment screw
1/4 of a turn and then check the result before turning it again.
When you have completed the adjustment, stop the belt with the STOP button.
Close the ap (A).
W
The treadmill belt may only be adjusted by trained personnel
or by the Technogym Technical Support Service due to the
presence of moving components.