Operation Manual

MYRUN TECHNOGYM
29
Easily solved problems
The following table lists a series of problems that may occur during normal use of the product. If the solutions indicated do not solve the problem, or if the
problem is not listed, ask the Technical Support Service for help.
Problem Cause Solution
The equipment does not
switch on
The power cable is not plugged into the wall socket. Plug the power cable into wall socket.
Mains power failure.
Check the power supply at the wall socket used by the
equipment by plugging in an appliance that denitely works.
Power supply cable damaged. Contact the Technogym Technical Support Service.
The power cable connector is not connected to the unit. Connect the connector.
The main switch is o. Turn on the main switch.
The main switch often turns itself o. Contact the Technogym Technical Support Service.
Too noisy Equipment not properly levelled. Check the position and level with the rear adjustment foot.
The treadmill is not centred.
Align the treadmill as described in the paragraph headed
"Aligning the treadmill".
Data incorrect or unreliable
with equipment running
Equipment next to source of radio interference (e.g.
electrical domestic appliances).
Move the equipment to another place or move the domestic
appliances.
The side handgrips do not
stay in place
The handgrip anchor lever is not fully raised.
Remove the handgrips and ret them onto the frame, as
described in the paragraph on this subject.