Operation Manual

TECHNICAL ISSUES

Problem Possible Causes Possible solutions

Dishwasher does Blown fuse or Check and replace fuse if

not start circuit breaker necessary. Reset circuit breaker

has been triggered. and remove any appliances

sharing the circuit.

Power supply is not Check the dishwasher is

switched on. switched on and the door

securely closed. Check the

power cord is correctly plugged

into the mains power source.

Error code E1 Check the water supply is

Water pressure is connected securely and the

too low faucet turned on.

Dishwasher door Ensure the door seal is free of

not properly closed. obstruction and the door is

securely closed.

Water is not pumped Drain hose is kinked Check the drainage hose is not

from the dishwasher kinked and is not squashed.

Filter is clogged Check and clean the ﬁ lter

Refer to page 15.

Clogged drain Check the drainage point is not

clogged. Consult your plumber.

Suds in the tub Improper detergent Only use detergent speciﬁ cally

designed for dishwashers.

When this occurs, open the

dishwasher door and allow

suds to evaporate. Pour 3-4

litres of cold water to the tub.

Close the dishwasher door

securely and select any wash

cycle. This will cause the

dishwasher to drain out the

water. Open the dishwasher

door after draining ﬁ nishes and

check if suds have

disappeared. Repeat process if

necessary.

Spilled rinse aid Always wipe up spilled rinse aid

immediately.

Stained tub interior Detergent with Choose a detergent without

colourant was used colourant.

TROUBLESHOOTING