User's Manual

Reference
10
CPS250 User Manual
Load 1
–5 V
2 A
Load 2
–5 to +15 V
Zero to 0.5 A
Load 3
–5 to +15 V
Zero to 0.5 A
Figure 4: Independent Ground-Referenced Applications (A)
Figure 5 shows the power supply connected to produce separate
outputs of +5 V, 0 V to +20 V from the B supply, and 0 V to –20 V
from the A supply. In this configuration the red terminal of output A
is the relative negative terminal because it is connected directly to
GND. To seu up this configuration, proceed as follows:
Load 1
+5 V
Zero to 2 A
Load 2
Zero to +20 V
Zero to 0.5 A
Load 3
Zero to –20 V
Zero to 0.5 A
Figure 5: Independent Ground-Referenced Applications (B)
1. Turn the CPS250 POWER to OFF. Connect the outputs as
shown in Figure 5.