User Guide

Teledyne API M100E Analyzer Operation Manual Remote Operation and Advanced Features
125
7.1.6.1. ETHERNET CARD COM2 COMMUNICATION MODES AND BAUD RATE
The firmware on board the Ethernet card automatically sets the communication modes for the COM2 port. The
baud rate is also automatically set at 115,200 Baud.
7.1.6.2. CONFIGURING THE ETHERNET INTERFACE OPTION USING DHCP
The Ethernet option for you M100E uses Dynamic Host Configuration Protocol (DHCP) to automatically
configure its interface with your LAN. This requires your network servers also be running DHCP. The analyzer
will do this the first time you turn the instrument on after it has been physically connected to your network. Once
the instrument is connected and turned on it will appear as an active device on your network without any extra
set up steps or lengthy procedures.
Should you need to, the following Ethernet configuration properties are viewable via the analyzer’s front panel.
04515F DCN6048