User Guide

Remote Operation and Advanced Features Teledyne API M100E Analyzer Operation Manual
136
To select a communication mode for a one of the COMM Ports, such as the following example where HESSEN
PROTOCOL mode is enabled, access the COMM Menu (refer to Figure 7-1), then press:
Continue pressing next until …
SETUP X.X COMMUNICATIONS MENU
ID COM1 COM2 EXIT
SETUP X.X COM1 MODE: 32
SET> EDIT EXIT
SETUP X.X COM1 QUIET MODE: OFF
NEXT OFF ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL : ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL : OFF
PREV NEXT OFF ENTR EXIT
Continue pressing the NEXT and PREV keys to select any other
modes you which to enable or disable
Use PREV and NEXT
keys to move between
available modes.
A mode is enabled by
toggling the ON/OFF
key.
Select which COM
port to configure
ENTR key accepts the
new settings
EXIT key ignores the
new settin
g
s
The sum of the mode
IDs of the selected
modes is displayed
here
Figure 7-14: COMM – Enable Hessen Protocol (Example)
04515F DCN6048