User Guide

ManualsBrandsTeledyne ManualsOther100E

161

162

163

164

165

166

167

168

169

170

Teledyne API M100E Analyzer Operation Manual Remote Operation and Advanced Features

161

7.3.2. REMOTE OPERATION USING THE EXTERNAL SERIAL I/O

7.3.2.1. TERMINAL OPERATING MODES

The M100E can be remotely configured, calibrated or queried for stored data through the serial ports. As

terminals and computers use different communication schemes, the analyzer supports two communicate modes

specifically designed to interface with these two types of devices.

 Computer mode is used when the analyzer is connected to a computer with a dedicated

interface program such as APICOM. More information regarding APICOM can be found in later

in this section or on the Teledyne API’s website at http://www.teledyne-

api.com/

oftware/apicom/.

 Interactive mode is used with a terminal emulation programs such as HyperTerminal or a

“dumb” computer terminal. The commands that are used to operate the analyzer in this mode

are listed in Table 7-10and in Appendix A-6.

7.3.2.2. HELP COMMANDS IN TERMINAL MODE

Table 7-10: Terminal Mode Software Commands

COMMAND FUNCTION

Control-T

Switches the analyzer to terminal mode (echo, edit). If mode flags 1 & 2 are OFF, the interface

can be used in interactive mode with a terminal emulation program.

Control-C Switches the analyzer to computer mode (no echo, no edit).

(carriage return)

A carriage return is required after each command line is typed into the terminal/computer. The

command will not be sent to the analyzer to be executed until this is done. On personal

computers, this is achieved by pressing the ENTER key.

(backspace)

Erases one character to the left of the cursor location.

ESC

(escape)

Erases the entire command line.

? [ID] CR

This command prints a complete list of available commands along with the definitions of their

functionality to the display device of the terminal or computer being used. The ID number of the

analyzer is only necessary if multiple analyzers are on the same communications line, such as

the multi-drop setup.

Control-C Pauses the listing of commands.

Control-P Restarts the listing of commands.

04515F DCN6048