User Guide

Teledyne API M100E Analyzer Operation Manual Remote Operation and Advanced Features
165
To initialize the modem, access the COMM Menu (refer to Figure 7-1), then press:
SETUP X.X COM1 MODEM INIT:AT Y

&D

&H
<SET SET> EDIT EXIT
SETUP X.X COM1 INITIALIZE MODEM
<SET SET> INIT EXIT
SETUP X.X COM1 MODE:0
SET> EDIT EXIT
SETUP X.X COM1 BAUD RATE:19200
<SET SET> EDIT EXIT
EXIT returns to the
Communications Menu.
SETUP X.X INITIALIZING MODEM
<SET SET> INIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID COM1 COM2 EXIT
Select which
COM Port is
tested
Figure 7-35: COMM – Initialize the Modem
7.3.2.7. COM PORT PASSWORD SECURITY
In order to provide security for remote access of the M100E , a LOGON feature can be enabled to require a
password before the instrument will accept commands. This is done by turning on the SECURITY MODE (refer
to Section 7.1.9). Once the SECURITY MODE is e
n
abled, the following items apply.
 A password is required before the port will respond or pass on commands.
 If the port is inactive for one hour, it will automatically logoff, which can also be achieved with the
LOGOFF command.
 Three unsuccessful attempts to log on with an incorrect password will cause subsequent logins to be
disabled for 1 hour, even if the correct password is used.
 If not logged on, the only active command is the '?' request for the help screen.
04515F DCN6048