User Guide

Teledyne API M100E Analyzer Operation Manual Remote Operation and Advanced Features
173
To assign or reset the status flag bit assignments, access the COMM Menu (refer to Figure 7-1), then press:
SETUP X. HESSEN STATUS FLAGS
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2 EXIT
SETUP X. PMT DET WARNING: 0002
PREV NEXT EDIT PRNT EXIT
Repeat pressing SET> until …
SETUP X. SYSTEM RESET: 0000
PREV NEXT EDIT PRNT EXIT
The <CH and
CH> keys move
the [ ] cursor left
and right along
the bit string.
Repeat pressing NEXT or PREV until the desired
message flag is displayed. Refer to Table 7-15.
For Example …
ENTR key accepts the
new settings
EXIT key ignores the
new settin
g
s
SETUP X. SYSTEM RESET: [0]000
<CH CH> [0] ENTR EXIT
Press the [?] key repeatedly to cycle through the available character set: 0-9
Note: Values of A-F can also be set but are meaningless.
Figure 7-40: COMM – Status Flag Bit Assignment
7.3.4.8. INSTRUMENT ID CODE
Each instrument on a Hessen Protocol network must have a unique ID code. The M100E is programmed with a
default ID code of 100. To change this code, refer to Section 7.1.1.
04515F DCN6048