User Guide

Optional Hardware and Software Teledyne API M100E Analyzer Operation Manual
54
5.3. CARRYING STRAP/HANDLE (OPT 29)
The chassis of the analyzer allows the user to attach a strap handle for carrying the instrument. The handle is
located on the right side and pulls out to accommodate a hand for transport. When pushed in, the handle is
nearly flush with the chassis, only protruding out about 9 mm (3/8”).
Figure 5-1: Carrying Strap Handle and Rack Mount Brackets
Installing the strap handle prevents the use of the rack mount slides, although the rack mount brackets, OPT 21,
can still be used.
CAUTION
GENERAL SAFETY HAZARD
A fully loaded M100E with valve options weighs about 18 kg (40 pounds).
To avoid personal injury We recommend two persons lift and carry the analyzer.
Ensure to disconnect all cables and tubing from the analyzer before carrying it.
5.4. CURRENT LOOP ANALOG OUTPUTS (OPTION 41)
This option adds isolated, voltage-to-current conversion circuitry to the analyzer’s analog outputs. This option
may be ordered separately for any of the analog outputs; it can be installed at the factory or added later. Call
Teledyne API sales for pricing and availability.
The current loop option can be configured for any output range between 0 and 20 mA. Information on calibrating
or adjusting these outputs can be found in Section 6.9.4.5.
04515F DCN6048