Wireless Adaptor Models GE863-QUAD, GE863-PY Hardware User Guide

GE863-QUAD

GE863-PY

1vv0300715 Rev. 1 - 19/09/06

NOTE: don't use any pull up resistor on the RESET# line nor any totem pole digital output.

Using pull up resistor may bring to latch up problems on the GE863-QUAD/PY power

regulator and improper functioning of the module. The line RESET# must be connected

only in open collector configuration.

TIP: The unconditional hardware reboot should be always implemented on the boards and

software should use it as an emergency exit procedure.

For example:

1- Let's assume you need to drive the RESET# pad with a totem pole output of a +3/5 V

microcontroller (uP_OUT2):