User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface
- 3.1 Power Supply
- 3.2 Power-up / -down Slew-Rate
- 3.3 Reset
- 3.4 Supply Voltage Monitor
- 3.5 Serial Interface
- 3.6 GPIO Interface
- 3.7 I2C Interface0F
- 3.8 SPI Serial Peripheral Interface1F
- 1.1
- 3.9 Bluetooth Radio Interface
- 3.10 WLAN Coexistence Interface2F
- 3.11 Slow Clock Interface
- 3.12 Test Mode Enable
- 3.13 Pin Strapped System Memory Boot Mode Invocation
- 3.14 Operating in a Power-Switched Environment
- 3.15 Serial Wire Interface
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 1
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
BlueMod+SR/AI
BlueMod+SR/AP
Hardware Reference
Release r04d01 www.stollmann.de Page 38 of 65
VSUP = 2,5V to 3,6V, Tamb = +85°C
Measured conducted according to BT specification v1.2/2.0/2.0 + EDR/2.1/2.1 + EDR/3.0/3.0 + HS/4.0
Transmitter
Frequency [GHz] Limit BT
Unit
RF transmit power
50 Ω load, at antenna
Class 1 device GFSK
b)
2.402 1,8 4,0
0 to 20 dBm
2.441 3,8 6,0
2.480 4,8 7,0
RF transmit power
50 Ω load, at antenna
Class 1 device EDR2, π/4
DQPSK
b)
2.402 GFSK 0,3
∆TX =
-4 to 1
dBm
2.402 π/4 DQPSK -0,8
2.441 GFSK 2,8
2.441 π/4 DQPSK 1,7
2.480 GFSK 4,0
2.480 π/4 DQPSK 2,9
RF transmit power
50 Ω load, at antenna
Class 1 device EDR3, 8DPSK
b)
2.402 GFSK 0,3
∆TX =
-4 to 1
dBm
2.402 8DPSK -0,8
2.441 GFSK
2,8
2.441 8DPSK 1,7
2.480 GFSK 4,0
2.480 8DPSK 2,9
20 dB bandwidth for modulated carrier 925 1000
≤1000
Initial carrier frequency tolerance -75 10 +75
≤ ±75
Carrier frequency drift (packet DH1) 7 25
≤ 25
Drift Rate 5 20 20
∆f1
avg
“Maximum Modulation”
140 164 175
≥140 to
≤175
∆f2
max
“Minimum Modulation”
115 140
≥ 115
kHz
∆f2
avg
/∆f1
avg
0,8 0,91
≥ 0,8
Table 17: RF Performance GFSK, PI/4 DQPSK, 8DPSK Transmitter
Notes:
(b) For calculating true performance add product specific antenna gain