User's Manual
Table Of Contents
- 1 Introduction
- 2 Block Diagram
- 3 Application Interface
- 3.1 Power Supply
- 3.2 Power-up / -down Slew-Rate
- 3.3 Reset
- 3.4 Supply Voltage Monitor
- 3.5 Serial Interface
- 3.6 GPIO Interface
- 3.7 I2C Interface0F
- 3.8 SPI Serial Peripheral Interface1F
- 1.1
- 3.9 Bluetooth Radio Interface
- 3.10 WLAN Coexistence Interface2F
- 3.11 Slow Clock Interface
- 3.12 Test Mode Enable
- 3.13 Pin Strapped System Memory Boot Mode Invocation
- 3.14 Operating in a Power-Switched Environment
- 3.15 Serial Wire Interface
- 4 Module Pins
- 5 Electrical Characteristics
- 6 Mechanical Characteristics
- 1
- 7 Application Diagram
- 8 Approvals/Certifications
- 9 Related Documents
- 10 Packing
- 11 Ordering Information
BlueMod+SR/AI
BlueMod+SR/AP
Hardware Reference
Release r04d01 www.stollmann.de Page 58 of 65
8.4 Bluetooth Qualification
The BlueMod+SR is a qualified design according to the Bluetooth Qualification Program Reference
Document (PRD) V2.1. The Qualified Design ID (QDID) is:
tbd
For further information about marking requirements of your product attention should be paid the
Bluetooth Product Marking Guide at
https://www.bluetooth.org/Download/Marking_Guide_20060601.pdf
According to the Bluetooth SIG rules (Qualification Program Reference Document – PRD V2.1)
you are required to perform the mandatory End Product Listing (EPL) for your product. For further
information see www.Bluetooth.org or contact Stollmann.