Manualshelf

Network Hardware User Manual

ManualsBrandsTelit Wireless Solutions ManualsNetwork HardwareUC864
31323334353637383940
UC864-E Hardware User Guide
1vv0300766a Rev.1 - 31/01/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 34 of 51
Second solution could be done using a MAXIM transceiver (MAX218)
In this case the compliance with RS232 (+-5V) is possible.
Another level adapting method could be done using a standard RS232 Transceiver (MAX3237EAI)
adding some resistors to adapt the levels on the UC864 Input lines.
NOTE: In this case has to be taken in account the length of the lines on the application to avoid
problems in case of High-speed rates on RS232.
The RS232 serial port lines are usually connected to a DB9 connector with the following layout: