User manual
© imec Messtechnik GmbH · V4.0-05/2016-EN · Technical Changes and Errors excepted
imec Messtechnik GmbH
Germany
Lilienthalstraße 23
74078 Heilbronn
T +49 7066.9150 230
F +49 7066.9150 233
info@imec.de
www.imec.de
10
User Manual
For tempbase.®-D V2 Software
13. Record Mode
Select “Stop when full” or “Ring Buer”
14. Stop Mode
Select “Stop by Button” or “Stop by Software“
15. Time Zone
Change the time zone (factory setting is UTC +00:00)
16. Battery Shows the battery status of the current device
17. Display Time Setup the time the display is active
18. Probe Mode Choose whether internal or external sensor should be used
19. Multiple Start/Stop
Enable • tempmate.®-M1 can be restarted after the device was stopped
Disable • tempmate.®-M1 can’t be restarted without configuration after the
device was stopped
20. Pause Enable or disable the “Pause” mode
21. Alarm
Choose the alarm setting between:
No Alarm • No alarm setting, only temp. recording
Single Alarm • A single “over” and “below” alarm point can be set
Multiple Alarm • Up to 3 “over” and 2 “under” alarm points can be set
22. Alarm Zones Enable or disable the desired alarm zones (depends on the alarm setting)
23. Temperature Choose the alarm temperature
24. Alarm Mode Choose between single or cumulative
25. Alarm Delay Choose the alarm delay
Save setting to program the logger
Save parameter settings
Load parameter settings
Back to home page
Temperature adjustment