User manual

imec Messtechnik GmbH

Germany

Lilienthalstraße 23

74078 Heilbronn

T +49 7066.9150 230

F +49 7066.9150 233

info@imec.de

www.imec.de

User Manual

For tempbase.®-D V2 Software

13. Record Mode

“Stop when full” is mandatory for tempmate.®-S1 V2

14. Stop Mode

Select “Stop by Button” or “Stop by Software“

15. Time Zone Change the time zone (factory setting is UTC +00:00)

16. Battery Shows the battery status of the current device

17. Alarm Setting

Choose the alarm setting between:

No Alarm • No alarm setting, only temperature recording

Single Alarm • A single “over” and “below” alarm point can be set

Multiple Alarm • Up to 3 “over” and 2 “under” alarm points can be set

18. Alarm Zones Enable or disable the desired alarm zones (depends on the chosen alarm setting)

19. Temperature Choose the alarm temperature

20. Alarm Mode Choose between single or cumulative

21. Alarm Delay Choose the alarm delay

Save setting to program the logger

Save parameter settings

Load parameter settings

Back to home page