Intelligent NiMH/NiCd/Li-ion Charger TN456 USER’S MANUAL www.Tenergy.
CONTENTS 1. Intended Use .........................................................................................3 2. Package Contents ..................................................................................4 3. Safety Instructions .................................................................................4 3.1 Product Safety .................................................................................4 3.2 Battery safety..................................................................
Tenergy 4-Bay NiMH/NiCd/Li-ion Intelligent Charger with Backlit LCD, TN456 Tenergy's TN456 is an intelligent charger designed for 1.2V NiMH / NiCd (A, AA, AAA, SC, C) and 3.7V Li-ion (26650, 22650, 26500, 18650, 17670, 18490, 17500, 17335, 16340(123A), 14500, 10440) rechargeable batteries. TN455 can be used to charge your batteries, as well as to test their capacities.
built-in overheat detection to protect rechargeable batteries and charger itself from getting too hot during use. The charger can only be used with the original power supply included with this charger. The charger can only be powered by the included power supply. Operate and store it in dry indoor environment only. This product fulfills European and national requirements related to electromagnetic compatibility (EMC). CE conformity has been verified and the relevant statements are available upon request.
Batteries must not be dismantled, short-circuited or thrown into fire. Never recharge non-rechargeable batteries as it may lead to explosion. If you have any queries about the device that are not answered user manual, please check with the distributor or manufacturer for further help. 4. Operating Elements CHANNEL buttons (1, 2, 3, 4): Select a battery compartment to customize the operation mode or current setting. MODE button: Lets you choose the operation mode (Charge, Test).
.1 Mode Selection Press and hold the MODE for 1 second to change the operating mode for all charging slots. Press MODE button again to toggle between the Charge and Test modes. After selecting the mode you can change the charging/discharging current pressing CURRENT. Mode selection can be activated for specific channel only by pressing the 1,2,3,4 channel buttons first, before following the instructions above. separately for specific battery compartment. 6.
Test mode: Checks the present capacity of a rechargeable battery. The maximum capacity is determined by discharging the rechargeable battery after it was fully charged. If the maximum capacity is much lower than the rated capacity then it may reach the end of its lifetime. Stage 1 Charge. Stage 2 Discharge. Stage 3 Discharge over, the second charge current selected. Stage 4 The testing process is over.
7.2 Display Charge/Discharge current: Shows the present charge/discharge current setting. Elapsed Time*: The charging/discharging time of the last cycle is displayed. Accumulated capacity: The accumulated battery capacity is displayed in mAh. Charge voltage: The instantaneous battery voltage is displayed.
use it in a well-ventilated area. Please unplug the power supply and remove your batteries from the charger's charging slots when the charger is not in use. The battery data displayed by this product is just for your reference only, and may differ from those measured with a professional equipment.
