User Manual

Table Of Contents

tage 2 Charge over

6.1 Mode Selection

 Press and hold the MODE for 1 second to change the operating mode for all

charging slots.

 Press MODE button again to toggle between the Charge and Test modes.

 After selecting the mode you can change the charging/discharging current

pressing CURRENT.

 Mode selection can be activated for specific channel only by pressing the 1,2,3,4

channel buttons first, before

following the instructions above. separately for specific

battery compartment.

6.2 Current selection

Within the first 8 seconds after inserting the batteries, press CURRENT to select desired

charge current of 300, 500, 700 or 1000m. To change the charging current and / or

operation mode again, press and hold MODE for 1 second, or press channel button 1-4

first and then press MODE to change the settings.

At any time during charger's opation, press DISPLAY to toggle between different display

options: voltage, current, capacity, inner resistance and elapsed time.

7. Operation Modes and Display

7.1 Operation Mode

Charge Mode: The rechargeable battery is charged up to its maximum capacity.

Stage1 Charge.